MATLAB® Solution Contents
Example 1.5	Strains in a plate
Example 2.3	Volume change of a cylinder under biaxial loads
Example 2.4	Material resilience on an axially loaded rod
Example 3.2	Design of a monoplane wing rod
Example 3.5	Maximum stresses in a simply supported beam
Example 4.8	Impact loading on a rod
Example 4.11	Impact loading on a shaft
Example 5.15	Stress in a strut of a clamping assembly
Example 5.17	Steel connecting rod buckling analysis
Example 6.2	Design of a wide plate with a central crack
Example 6.4	Failure of a rod under combined torsion and axial loading
Example 7.1	Endurance limit of a torsion bar
Example 7.7	Fatigue life of instrument panel with a crack
Example 8.2	Maximum contact pressure between a cylindrical rod and a beam
Example 8.3	Ball bearing load capacity
Example 9.3	Shaft design for repeated torsion and bending
Example 9.5	Determining critical speed of a hollow shaft
Example 10.1	Preliminary design of a boundary-lubricated journal bearing
Example 10.5	Median life of a deep-groove ball bearing
Example 11.2	Gear tooth and gear mesh parameters
Example 11.3	Contact ratio of meshing gear and pinion
Example 12.2	Electric motor geared to drive a machine
Example 12.4	Geometric quantities of a worm
Example 13.3	Design analysis of a V-belt drive
Example 13.6	Design of a disk brake
Example 14.2	Allowable load of a helical compression spring
Example 14.8	Design of a nine-leaf cantilever spring
Example 15.1	Quadruple-threaded power screw
Example 15.5	Preloaded bolt connecting the head and cylinder of a pressure vessel
Example 16.1	Designing a press fit
Example 17.2	Displacements in a frame
Case study 1.1	Bolt cutter loading analysis
Case study 3.1	Bolt cutter stress analysis
Case study 4.1	Bolt cutter deflection analysis
Case study 7.1	Camshaft fatigue design of intermittent-motion mechanism
	
Case study 8.1	Cam and follower stress analysis of an intermittent-motion mechanism
Case study 9.1	Motor-belt-drive shaft design for steady loading
Case study 18.1	Entire frame load analysis
Case study 18.2	Design analysis of Arm CD
Case study 18.7	Screw design for swivel hook
Case study 18.11	Brake design analysis